對這文章發表回應
發表限制: 非會員 可以發表
發表者： 冷日 發表時間： 2005/3/29 7:51:39
可以試試看ifport,
ifport可以設定網路卡的連線模式有 auto, 10baseT, 10base2,aui, and 100baseT等幾種. 主要是方便系統管理員, 針對無法自動設定正確網路連線模式的網路卡, 改用指定方式設定.
這裡順便提供 ifport 的 man page :
usage: ifport interface [auto|10baseT|10base2|aui|100baseT|##]
ifport可以設定網路卡的連線模式有 auto, 10baseT, 10base2,aui, and 100baseT等幾種. 主要是方便系統管理員, 針對無法自動設定正確網路連線模式的網路卡, 改用指定方式設定.
這裡順便提供 ifport 的 man page :
IFPORT(8) IFPORT(8)
NAME
ifport - select the transceiver type for a network interface
SYNOPSIS
ifport interface [auto|10baseT|10base2|aui|100baseT|##]
DESCRIPTION
Ifport sets the transceiver type for the specified network interface, for drivers that support multiple transceiver types. If a type
is not specified on the command line, then the current type is displayed. The type can be specified either numerically or by keyword.
The five standard transceiver types (auto, 10baseT, 10base2, aui, and 100baseT) correspond to codes 0 to 3, for all the Linux PCMCIA
network drivers. The keyword match is case insensitive.
The network drivers may not reconfigure a card for a new transceiver type if the interface is already open. It is best to invoke
ifport prior to configuring the interface with ifconfig to ensure that the new setting takes effect immediately.
This utility only works with a limited set of 16-bit PC Card drivers: 3c589_cs, nmclan_cs, pcnet_cs, smc91c92_cs, and xirc2ps_cs. If
invoked for other drivers, ifport may report bogus transceiver settings, or report ``Operation not supported''.
DIAGNOSTICS
ioctl: Operation not supported
Indicates that this network device does not support manual transceiver selection. There may be only one transceiver option, or
the device may always autodetect the appropriate transceiver.
AUTHOR
David Hinds - dhinds@pcmcia.sourceforge.org
SEE ALSO
ifconfig(8).
pcmcia-cs 1999/11/02 20:34:56 1